How to Mount EST Bindings

This video demonstration will guide you through installing EST bindings onto your snowboard. Burton EST bindings utilise the channel system, which is among the most prevalent snowboard binding systems today:

1. Begin by ensuring your binding is an EST type. It should contain a channel insert.
2. Use a flat screwdriver to detach the rubber cover from the channel.
3. Place the EST mounting hardware inside the channel.
4. Proceed to open the binding.
5. Remember, the board comes with a suggested mounting position.
6. Align your binding with the hardware recently inserted.
7. Push the channel insert down to fix it within the channel.
8. Utilise the supplied screws and commence screwing them into the board with a Phillips screwdriver, keeping them loose initially.
9. Ensure the binding moves without restraint at this stage.
10. Adjust the binding according to the markers marked on the board.
11. Finally, tighten the screws completely and put the rubber cover back in place.

Your bindings are now securely installed!